Integra DSR-4.8 - Manual (Page 28)

28
Connecting the Power/Turning on the DVD receiver
Before connecting
• Make sure that all the connections on pages 17–27 are
complete (the connection to a TV is required).
Note:
DVD receiver features a screen saver and an auto power
off function. If the receiver is stopped and no button is
pressed for 15 minutes, the screen saver starts (see
page 63).
1 Plug the supplied power cord into
the AC INLET and then into the
power outlet on the wall.
• Do not use a power cord other than the
one supplied with the DVD receiver.
The power cord supplied is designed
for use with the DVD receiver and
should not be used with any other
device.
• Never have the power cord discon-
nected from the DVD receiver while
the other end is plugged into the wall
outlet. Doing so may cause an electric
shock. Always connect by plugging
into the wall outlet last and disconnect
by unplugging from the wall outlet
first.
Standby/On
Standby/On
Standby indicator
• Before unplugging the receiver from
the power outlet, make sure you first
switch it into standby.
• For the above reasons, do not plug this
receiver into a switched power supply
found on some amplifiers and AV
receivers.
2
DVD receiver
Remote
controller
Press [Standby/On] button on the
DVD receiver or the remote con-
troller.
Turn on your TV and select the
input through which the DVD
receiver is connected.
The DVD receiver turns on and the
Standby indicator turns off.
• To put the DVD receiver in the standby
mode, press [Standby/On] on the DVD
receiver, or [Standby/On] on the
remote controller.
• While the Standby indicator lights up,
the DVD receiver can receive signals
from the remote controller.
• Setting the [Standby/On] button to
standby does not shut off the power
completely.
To a wall outlet