Integra DSR-4.8 - Manual (Page 25)

25
Connecting the DVD receiver—Continued
■ iPod with video or RI Dock with the OSD mode
Connect your RI Dock’s analog audio output jacks
and Video output jack to the DVD receiver’s
VIDEO 2/DOCK INPUT L/R jacks and V jack.
Connect the RI Dock with an
cable. (Onkyo
DS-A1X/A2/A2X hookup shown below.)
■ iPod without video
Connect your RI Dock’s analog audio output jacks to
the DVD receiver’s VIDEO 2/DOCK INPUT jacks.
Connect the RI Dock with an
cable. (Onkyo
DS-A1 hookup shown below.)
You can use optical/coaxial digital cable instead of the audio cable when connecting with other AV components.
Connect your AV component’s digital audio output jack to corresponding COAXIAL or OPTICAL DIGITAL AUDIO
IN jack of the DVD receiver.
You must assign that jack to an input (see page 56).
Notes:
• Optical digital audio input is assigned for VIDEO 1
INPUT in default.
If you output audio from this input during VIDEO 2/
DOCK INPUT is selected, you must change the
“Video2 Input” setting to “OPT” from “Coax”.
• Coaxial digital audio input is assigned for VIDEO 2/
DOCK INPUT in default.
If you output audio from this input during VIDEO 1
INPUT is selected, you must change the “Video1
Input” setting to “Coax” from “OPT”.
Connecting an RI Dock
Notes:
• Set the RI Dock’s RI MODE switch to HDD or HDD/DOCK.
• Press the Input [ ]/[ ] buttons to select “VIDEO2/DOCK”.
• Refer to the RI Dock’s instruction manual.
Digital Audio Connection
VIDEO
OUT COAXIAL OPTICAL
Set top box,
VCR, DVD
Recorder
Connect one
or the other