Insignia X7510 - Manual (Page 24)

Getting Started
1.2 Installing the USIM/SIM Card, Storage Card
and Battery, and Charging the PDA Phone
Always turn off your device before installing or replacing the USIM/SIM card,
storage card, and battery. You also need to remove the back cover before you
can install these components.
To remove the back cover
1. Make sure your device is
turned off.
2. Place the device face down on
a clean and stable surface.
3. Slide up the battery
compartment cover, then flip
it down to access the battery
bay, USIM/SIM card slot, and
miniSD™ card slot.
USIM/SIM card slot
Battery bay
miniSD card slot
Note To close the battery compartment cover, flip it up and align it with the battery
compartment, then slide it down until it fits into place.
USIM/SIM card
The G USIM (Universal Subscriber Identity Module) or SIM (Subscriber Identity
Module) card contains your phone number, service details, and phonebook/
message memory. Your device supports both 1.8V and V USIM/SIM cards.
Note Some legacy SIM cards may not function with your device. You should consult
with your service provider for a replacement SIM card. There may be fees for this
service.
To install the USIM/SIM card
1. Make sure your device is
turned off.
2. Locate the USIM/SIM card
slot inside the battery
compartment, then flip up the
USIM/SIM card slot door.
USIM/SIM card
slot door