Mitsubishi Motors DS5000TK - Manual (Page 32)

USER’S GUIDE
050396 31/173
32
PCON.3: EPFW
“Enable Power Fail Interrupt”: Used to enable or disable the Power Fail Interrupt. When EPFW is set to a 1,
it will be enabled; it will be disabled when EPFW is cleared to a 0.
Initialization: Cleared to a 0 on any type of reset.
Read Access: Can be read normally anytime.
Write Access: Can be written normally anytime.
PCON.2: EWT
“Enable Watchdog Timer”: Used to enabled or disable the Watchdog Timeout Reset. The Watchdog
Timer is enabled if EWT is set to a 1 and will be disabled if EWT is cleared
to a 0.
Initialization: Cleared to a 0 on a No–V
LI
Power on Reset. Remains unchanged during
other types of reset.
Read Access: May be read normally anytime.
Write Access: Can be written only by using the Timed Access register.
PCON.1: STOP
“Stop”: Used to invoke the Stop mode. When set to a 1, program execution will ter-
minate immediately and Stop mode operation will commence. Cleared to a 0
when program execution resumes following a hardware reset.
Initialization: Cleared to a 0 on any type of reset.
Read Access: Can be read anytime.
Write Access: Can be written only by using the Timed Access register.
PCON.0: IDL
“Idle” Used to invoke the Idle mode. When set to a 1, program execution will be
halted and will resume when the idle bit is cleared to 0 following an interrupt
or a hardware reset.
Initialization: Cleared to 0 on any type of reset or interrupt.
Read Access: Can be read normally anytime.
Write Access: Can be written normally anytime.