Marantz DL5500 - Manual (Page 33)

33
USING THE REMOTE TO CONTROL
SET-TOP-BOX/SATELLITE RECEIVER FUNCTIONS
Operating the precoded function for your satellite receiver.
This remote is designed to operate different types of set-top-box/satellite systems. You must first program the remote to match the
remote system of your set-top-box/satellite receiver. (refer to page 36)
1. Turn ON your set-top-box/satellite receiver.
2. Aim the remote control at the front of your set-top-box/satellite receiver.
3. Press and release the SET-TOP-BOX (STB) button to switch to set-top-box/satellite pre-coded mode.
4. Hold down the STB button on the remote and enter the two digit preset code that matches your set-top-box/satellite receiver as
shown on page 36. The indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the set-top-box/satellite receiver and press the OFF button. The remote will turn off your set-top-box/satellite
receiver when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your set-top-
box/satellite receiver. If the set-top-box/satellite receiver does not turn off, try a different two digit preset code.
6. The remote will now control your set-top-box/satellite receiver.
NOTES:
1.
If your set-top-box/satellite receiver cannot be operated
after performing the above procedures, your set-top-
box/satellite receiver code has not been precoded into the
remote.
2. In the unlikely event that your set-top-box/satellite
receiver cannot be operated after performing the above
procedures, please consult your set-top-box/satellite
receiver operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4. The ANT button will act as the TV/STB button when in
STB mode.
ቢ
SET-TOP-BOX (STB) button
This button allows the remote to control your set-top-
box/satellite receiver by setting it to SET-TOP-
BOX/SATELLITE mode.
ባ
PRECODED SET-TOP-BOX/SATELLITE RECEIVER buttons
These buttons transmit the chosen precoded satellite codes.
ቤ
EXCLUSIVE TV buttons
These buttons are for operating the TV.
ባ
ባ
ቤ
ባ
ባ ቤ
ቤ
ባ
ቤ
ባ
ቤ
ቢ
ON
TV VCR CBL
TAPE CD
AMP
STB
DVD
1 2
4 5 6
3
7 8 9
0 LAST CH SLEEP
ANT
HELP
C.S.
EXIT
MENU
CH VOL
STATUS
MUTE
GUIDE/TV GUIDE/TV GUIDE/TV INFO
VCR PLUS+
SVCS
GUIDE/TV
SCHD
PIP PIP CH
SWAP
FREEZE
PIP MODE
PIP ACCESS
PROG TV/VCR SLOW
SOURCE WIZARD
REC
SELECT
TV/PC ASPECT
OFF
VID1
VID2 VID3
RC5500DL
MY SET-TOP-BOX/
SATELLITE CODE IS:
NOTE: Refer to instruction manual of the Set-Top-Box/Satellite Receiver for operation of the buttons exclusively for the Set-Top-
Box/Satellite Receiver.