Using the remote to control vcr function, My vcr code is – Marantz DL5500 User Manual
Page 31
31
USING THE REMOTE TO CONTROL VCR FUNCTION
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your
VCR. (refer to page 36 for pre-codes)
1.
Turn ON your VCR.
2.
Aim the remote control at the front of your VCR.
3.
Press and release the VCR button to switch to VCR pre-coded mode.
4.
Hold down the VCR button on the remote and enter the two digit preset code that matches your VCR, as shown on page 36. The
indicator light will flash 3 times if the code was accepted.
5.
Aim the remote at the VCR and press the OFF button. The remote will turn off your VCR when the correct two digit preset code is
entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off, try a different two digit
preset code.
6.
The remote will now control your VCR.
NOTES:
1.
If your VCR cannot be operated after performing the
above procedures, your VCR’s code has not been
precoded into the remote.
2.
In the unlikely event that your VCR cannot be operated
after performing the above procedures, please consult
your VCR operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4.
The LAST CH button will act as your VCR ENTER button
if required.
5.
The SLEEP button will act as your VCR ‘100’ button if
required.
ቢ
VCR Button
This button allows the remote to control your VCR by setting
it to VCR mode.
ባ
PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes.
For some VCRs, you must press the RECORD button twice
to record a program.
ቤ
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
ቢ
ባ
ቤ
ባ
ቤ
ባ
ቤ
ባ
ባ
ቤ
ON
TV
VCR
CBL
TAPE
CD
AMP
STB
DVD
1
2
4
5
6
3
7
8
9
0
LAST CH
SLEEP
ANT
HELP
C.S.
EXIT
MENU
CH
VOL
STATUS
MUTE
GUIDE/TV
GUIDE/TV
GUIDE/TV
INFO
VCR PLUS+
SVCS
GUIDE/TV
SCHD
PIP
PIP CH
SWAP
FREEZE
PIP MODE
PIP ACCESS
PROG
TV/VCR
SLOW
SOURCE WIZARD
REC
SELECT
TV/PC
ASPECT
OFF
VID1
VID2
VID3
RC5500DL
MY VCR CODE IS:
NOTE:
Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.