Marantz DL5500 - Manual (Page 19)

19
CONNECTING EXTERNAL VIDEO SOURCES
CONNECTING A STEREO VCR OR STEREO LASERDISC PLAYER
1. Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the VIDEO input (VIDEO) jack, as shown on the
TV set below.
2. Connect the cable from the AUDIO OUT R of the VCR or the laserdisc player to the VIDEO input (AUDIO/R) jack.
3. Connect the cable from the AUDIO OUT L of the VCR or the laserdisc player to the VIDEO input (AUDIO/L) jack.
4. Press the VID1~VID3 button to view the program from the VCR or laserdisc player. The VIDEO icon disappears automatically
after approximately eight seconds.
5. Press the ANT button to return to the previous channel.
ANT A
TO
CONVERTER
ANT B
1 2 3 4 5
6 7 8 9 10
11 12 13 14 15
AUDIO
L
R
(MONO)
VIDEO VIDEO
AUDIO
(MONO)
L
R
AUDIO
(MONO)
L
R
VIDEO
S-VIDEO S-VIDEO
Y
B
R P
B
R P
P
S-VIDEO
L
R
STOP
CONNECT ONLY 8 OHM SPEAKERS
DO NOT SHORT CIRCUIT
THESE TERMINALS
(Such damage is NOT COVERED
by your television warranty)
REAR SPEAKER 8 Ω ONLY
-
L
+
- +
R
PC 1
AUDIO
INPUT
MONITOR
OUT
VIDEO 2 VIDEO 1
AUDIO OUT
L
R
SUB
WOOFER
OPTICAL COAXIAL
DIGITAL IN
Back of
VCR
R L V
VCR
OUTPUT
P
Y
NOTES: 1. Completely insert the connection cord plugs when connecting to rear panel jacks. The picture and sound that is
played back will be abnormal if the connection is loose.
2. A single VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line output.
(INPUT: 1 in example on page 13) Refer to your VCR operating guide for more information on line input-output
connections.