Hitachi MK-97DF8018-00 - Manual (Page 44)

6–2 Using SnapShot
Hitachi Simple Modular Storage Copy-on-Write SnapShot User’s Guide
SnapShot Replication Workflow
Following the initial creation of the SnapShot pair, which is a one time
operation, a SnapShot workflow includes the following basic processes:
• Back up a volume
• Update the V-VOL
• Restore the P-VOL from the V-VOL
• Delete the pair, V-VOL, and data pool
• Edit the pair and data pool
The following sections describe these processes.
Back Up Your Volume—Create a Pair
During the short time that a snapshot copy is being created, the P-VOL
remains accessible to the host. The V-VOL is unavailable until the snapshot
is complete and the pair is split.
• There are two ways to back up a volume using the Navigator 2 GUI.
- Use the backup wizard, described below. This is the simplest and
quickest method. Preparation consists of the following:
• Make sure the primary volume is set up on the array. See
Table B-1 on page B-2 for primary volume specifications.
• Create a data pool by assigning a volume. See Assign Volumes
for the Data Pool on page 5-2 .
- Use the create pair procedure, which allows more
customization—described on Page 6-3. This is a more involved
method that allows you to set copy pace, assign the pair to a
group (and create a group), and automatically split the pair after it
is created. Preparation consists of the following:
• Make sure the primary volume is set up on the array. See
Table B-1 on page B-2 for primary volume specifications.
• Create a data pool by assigning a volume. See Assign Volumes
for the Data Pool on page 5-2
• Set up the V-VOL. See Set Up the Virtual Volume (V-VOL)
(manual method) on page 5-3
• (Advanced users using Navigator 2 CLI, please see Creating SnapShot
Pairs on page A-5 .)
Using the Backup Wizard
1. In Navigator 2 GUI, select the desired array, then click the Show &
Configure Array button. The
2. On the array page under Common Array Tasks, click the Backup
Volume link. The Backup Your Volume Wizard window opens.
3. On the Introduction screen, click Next. The Select Primary Volume
screen displays.