haier PH-4210D User Manual

Page 10

10 Plasma TV

Do not leave a still picture from a VCR on the screen for an extended period. If the 4:3 format is used, the fixed images on the
sides of the screen may remain visible on the screen if this format is used day after day. This is known as burn-in, and it
is an uneven wear of the screen area. Reduce contrast when displaying fixed images on the screen for long periods.

- To avoid picture noise (interference), leave an adequate distance between the VCR and TV

Do not connect both Video and
S-Video at the same time.
If you connect both Video
and the S-Video cables, only the
S-Video will work. Do not connect
S-Video if you want to use the
Video connection.

Connect the audio and video cables from the

VCR's output jacks to the

input jacks,

as shown in the figure.
When connecting the

to VCR, match

the jack colors (Video = yellow, Audio Left = white,
and Audio Right = red).
If you connect an S-VIDEO output from VCR to
the S-VIDEO input, the picture quality is
improved; compared to connecting a regular
VCR to the Video input.

Insert a video tape into the VCR and press

PLAY on the VCR. (Refer to the VCR owner`s
manual.)

. Select the input source by the INPUT button

on the remote control.

- After subscribing to a cable TV service from a local provider you can watch cable TV programming. The

cannot

display TV programming unless a TV tuner device or cable TV converter box is connected to the

- For further information regarding cable TV service, contact your local cable TV service provider(s).

If you have a cable box, connect the audio and video cables from the

cable box's output jacks to the TV`s AV IN input jacks, as shown in the figure.
When connecting the TV to a Cable Box, match the jack colors
(Video = yellow, Audio Left = white, and Audio Right = red).
(If you have a digital cable box please refer to page 12 , for DTV setup)

. Select the input source by using the INPUT button on the

remote control. (If connected to AV IN, select AV1/S-VIDEO input source)

Select your desired channel with the remote control for cable box.

ANT IN

. Connect the co-axial cable from your wall jack to the

antenna in of the TV for direct cable programming.

(Co-axial)