Harbor Freight Tools 97503 - Manual (Page 19)

Page 19 SKU 97503 For technical questions, please call 1-800-444-3353.
Incorrect line voltage: •
Check the line voltage and, if
insufficient, have a licensed
electrician remedy the situation.
wire Feeds, but arc does not ignite
Possible Causes and Solutions:
Improper ground connection: •
Make certain that the work piece is
contacted properly by the Ground
Clamp and that the work piece is
properly cleaned near the ground
clamp and the welding location.
Improperly sized or excessively
•
worn Contact Tip:
Verify that Contact Tip is the proper
size for the welding wire used.
Check that the hole in the tip is
not deformed, enlarged, or dirty. If
needed, replace Contact Tip with
proper size and type.
wire Feeds, but Shielding gas does not
Flow
Possible Causes and Solutions:
Empty Gas Cylinder: •
Check gas cylinder.
Nozzle Plugged:
•
Clean nozzle. If damaged, replace.
Regulator or cylinder valve closed:
•
Make sure both valves are adjusted
properly.
Gas line blocked:
•
Check external hose, and hose
within Torch cable.
Gas solenoid broken or not
•
connected properly:
Have a qualified technician check/
replace.
pleaSe reaD tHe FOllOwInG
careFullY
THE MANUFACTURER AND/OR DISTRIBUTOR
HAS PROVIDED THE PARTS LIST AND ASSEMBLy
DIAGRAM IN THIS MANUAL AS A REFERENCE
TOOL ONLy. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANy REPRESENTATION
OR WARRANTy OF ANy KIND TO THE BUyER
THAT HE OR SHE IS qUALIFIED TO MAKE ANy
REPAIRS TO THE PRODUCT, OR THAT HE OR
SHE IS qUALIFIED TO REPLACE ANy PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR ExPRESSLy STATES
THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN By CERTIFIED AND
LICENSED TECHNICIANS, AND NOT By THE
BUyER. THE BUyER ASSUMES ALL RISK AND
LIABILITy ARISING OUT OF HIS OR HER REPAIRS
TO THE ORIGINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS
THERETO.