Harbor Freight Tools 97503 - Manual (Page 12)

Page 12 SKU 97503 For technical questions, please call 1-800-444-3353.
Inlet located on the Back Panel of the
Welder.
Adjust the flow rate of the gas by
27.
turning the Flow Adjust. The typical
flow rate is 10-30 CFH (cubic feet
per hour). Check the Welding Wire
manufacturer’s recommended flow
rate.
Installation of a line-in, where
28.
necessary, and connecting a
twist-lock plug to the power cord
must be performed by a licensed
electrician.
OperatInG InStructIOnS
read the entIre IMpOrtant
SaFetY InFOrMatIOn section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
tool Set up
tO preVent
SerIOuS InjurY
FrOM accIDental
OperatIOn:
turn the switch to its off
position before performing
any inspection, maintenance,
or cleaning procedures.
work piece and work area Set up
Designate a work area that is clean 1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the power cord along a safe
2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to
allow free movement while working.
Secure loose work pieces using
3.
a vise or clamps (not included) to
prevent movement while working.
The work pieces should be firmly
held together and in position while
welding. The distance (if any)
between the two work pieces must
be controlled properly to allow the
weld to hold both sides securely while
allowing the weld to penetrate fully
into the joint.
There must not be hazardous
4.
objects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
A barrier, such as a welding curtain
5.
or welding shroud should be put up
to protect others in the work area and
limit the spray of sparks.
General Operating Instructions
protective gear
must be worn
when using the MIG welder;
anSI-approved, arc shaded,
eye protection, a full face
shield, heavy-duty work
gloves, a welding apron,
respirator, and heavy-duty
work clothes without pockets
should be worn when using
this product. Do not look at
the ignited arc without eye
protection. light from the arc
can cause permanent damage
to the eyes. light from the
arc can burn the skin. Do not
breathe arc fumes.
warnInG
DanGer