Cylinder and piston – Husqvarna 343R User Manual
Page 51
50
6
Cylinder and piston
Wear tolerances
When the surface coating is
worn and aluminium appears.
Max. 1.0 mm with the piston
ring inserted in the lower part
of the cylinder.
Max. 1.6 mm. Clean the groove
before checking the measure-
ment.
Max. 0.15 mm. Clean the groove
before checking the measure-
ment.
Piston ring play
Piston ring groove
Piston ring gap
Cylinder bore
This manual is related to the following products:
See also other documents in the category Husqvarna Petrol tool:
- 455 Rancher (44 pages)
- 372XPW (44 pages)
- 327P4 (36 pages)
- 436 LI (44 pages)
- 115 13 81-26 (44 pages)
- 318 (24 pages)
- 320 (25 pages)
- 385XP (40 pages)
- 390XP (44 pages)
- OPERATORS MANUAL CS 2159W (44 pages)
- 362XP (44 pages)
- 371XP (36 pages)
- 365 (40 pages)
- 372XP (40 pages)
- 1151375-95 (44 pages)
- 1153179-95 (44 pages)
- 1151436-95 (44 pages)
- 232R (36 pages)
- 232RD EN (30 pages)
- 232R (44 pages)
- 232RD (44 pages)
- 235R (52 pages)
- 23 COMPACT (15 pages)
- 50 Special (42 pages)
- 135E (420 pages)
- 576 XP EPA III (44 pages)
- 246 (36 pages)
- 236E (23 pages)
- 1151002-95 (45 pages)
- 576XP AutoTune (44 pages)
- 1151338-95 (44 pages)
- 1153183-26 (44 pages)
- 575XP (48 pages)
- 570 (44 pages)
- 353 E-tech (44 pages)
- EPA III (132 pages)
- 394XP (36 pages)
- TrioBrake 345e EPA II (44 pages)
- 340E EPA II (48 pages)
- 261 (36 pages)
- TAC 345e (44 pages)
- 1153136-95 (36 pages)
- 450e (44 pages)
- 445 (44 pages)
- 346XP/ 351 (44 pages)