Husqvarna 343R - Manual (Page 11)

10
2
502 50 06-01
502 51 34-02
0.3
Electrical system
Replacing the spark
plug cover
1. Insert the ignition cable through the
spark plug cover.
2. Make a hole in the ignition cable for
the ignition coil.
Replacing the spark
plug cover
1. Lubricate the ignition cable with a
little grease and thread it through
the spark plug cover.
2. Cut off a bit of the ignition cable
(approx. 5 mm) and make a hole in
the cable for the ignition coil with
the aid of a pair of no. 502 50 06-01
pliers.
3. Attach the ignition coil to the ignition
cable.
3. Attach the ignition coil to the ignition
cable and ensure that the wire is
folded along the cable.
4. Pull the ignition coil into the spark
plug cover.
NOTE!
It is important that the tip of the ignition coil hits the centre of the
ignition cable to prevent sparking.
Adjust the air gap. Adjust the air gap as needed to the
correct value.
• Loosen the bolts.
• Position the feeler gauge and press
the ignition module against the
flywheel.
• Tighten the bolts and check the air
gap again.
If the spark plug still does not fire, the
ignition system should be replaced.
Still no spark?
Check the air gap.
Still no spark?
Check the air gap between the flywheel
magnet and the ignition module. The
gap should be 0.3 mm.
Use a 502 51 34-02 feeler gauge.