Humax IR-FOX C - Manual (Page 49)

**
3. Network ID
1. Select Network ID using the button, and
press the OK or button.
2. Enter the network ID using the NUMERIC(0-9)
buttons and press the OK
button.
4. Search
You can complete the setting and start searching.
1. Select Search and press the OK button to
start Channel Search.
2. Wait while the product searches for the
channels, this may take a few minutes.
3. During operating search, the cursor is located
at Stop. Therefore, if you press the OK
button during searching, the operation is
stopped and only the channels found so far will
be displayed.
4. If the search operation is successfully
completed, and no channels are found, press
the OK
button and try to reset the search
operation again if necessary.
5. When completing channel search, select Save,
and press the OK
button to save the
changes.
**
8. Installation
GB 48