Hoshizaki DT-400BAH-OS - Manual (Page 6)

6
II. Installation and Operating Instructions
A. Checks Before Installation
IMPORTANT
1. Install in accordance with all applicable national, state, and local regulations.
2. Ensure all components, fasteners, and thumbscrews are securely in place
after installation.
3. Remove the shipping carton, tape, and packing material. If any are left in the
icemaker, it will not work properly.
1) Remove the panels to prevent damage when installing the icemaker. See "II.B. How to
Remove Panels."
2) Remove the package containing the accessories.
3) Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
4) Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade turns freely.
5) Check that the compressor is snug on all mounting pads.
6) See the nameplate on the rear panel, and check that your voltage supplied corresponds
with the voltage specified on the nameplate.
B. How to Remove Panels
See Fig. 1
• Upper Front Panel: Remove the screw. Lift up and towards you.
• Top Panel: Remove the thumbscrew. Lift up
at front slightly, push rearward and lift off.
• Apron Panel: Remove the screws and pull
towards you.
• Side Panel: Remove the screws. Slide
forward slightly, and lift off.
• Lower Front Panel: Remove the screw and
pull towards you.
Fig. 1
Apron Panel
Side Panel
Upper Front Panel
Side Panel
Top Panel
Lower Front Panel