Hoshizaki DT-400BAH-OS - Manual (Page 15)

15
8) Allow the icemaker to sit for about 10 minutes before operation. If you placed a clamp
on the reservoir hose in step 7, remove it before operation.
9) Plug the icemaker back in. Move the power switch to the "ON" position and replace the
panels in their correct positions.
10) Move the control switch to the "ICE" position. Run the icemaker until it stops
automatically.
11) Move the control switch to the "DRAIN" position, and wait about 15 minutes for the
water system to drain.
12) After the water has drained, move the control switch to the "OFF" position. Remove the
upper front, top and left side panels.
13) Move the power switch to the "OFF" postion. Unplug the icemaker from the electrical
outlet.
14) Disconnect the ice transport hose from the spout, and pour fresh water into the ice
transport hose to rinse out the solution and fill the evaporator and reservoir. Be careful
not to overfill the reservoir. Reconnect the transport hose.
15) Plug the icemaker back in. Move the power switch to the "ON" position and replace the
panels in their correct positions.
16) Move the control switch to the "ICE" position. Run the icemaker until it stops
automatically.
17) Move the control switch to the "DRAIN" position, and wait about 15 minutes for the
water system to drain.
Note: If you do not sanitize the icemaker, go to step 14 in "4. Sanitizing Procedure."
3. Sanitizing Solution
Dilute approximately 0.82 fl. oz. (25 ml) of a 5.25% sodium hypochlorite solution
(chlorine bleach) with 1.6 gallons (6.0 l) of warm water.
4. Sanitizing Procedure - Following Cleaning Procedure
1) Move the control switch to the "OFF" position and remove the upper front, top and left
side panels.
2) Move the power switch to the "OFF" position. Unplug the icemaker from the electrical
outlet.
3) Disconnect the ice transport hose from the spout, and pour the sanitizing solution into
the ice transport hose. Be careful not to overfill the reservoir. Reconnect the transport
hose.
4) Plug the icemaker back in. Move the power switch to the "ON" position and replace the
panels in their correct positions.
5) Allow the icemaker to sit for about 10 minutes before operation, then move the control
switch to the "ICE" position. Run the icemaker until it stops automatically.
6) Move the control switch to the "DRAIN" position, and wait about 15 minutes for the
water system to drain.
7) Repeat steps 1 through 6 one time.