Hoshizaki DT-400BAH-OS - Manual (Page 18)

18
9) Immerse the parts removed in steps 4 through 8 in the cleaning and sanitizing solutions
for about 15 minutes each.
10) Rinse these parts thoroughly with clean water.
11) Thoroughly wipe the shutter located above the ice dispensing spout.
12) Reassemble the bin control bracket assembly.
13) Place the auger (ice dispensing), agitator, bin control bracket assembly, spout, packing,
ice dispensing spout, water dispensing nozzle and spout cover back in position.
14) Clean the storage bin liner, and rinse thoroughly.
15) Plug the icemaker back in. Move the power switch to the "ON" position and replace all
parts and panels in their correct positions.
16) Move the control switch to the "ICE" position to start the automatic icemaking process.
8) Remove the thumbscrews, spout cover, ice dispensing spout, and water dispensing
nozzle. See Fig. 10.
Fig. 10