HP SR2122-2 - Manual (Page 12)

Known problems
12 SR2122-2 IP Storage Router Release Notes
For example, if the offset for the SR2122-2 connection is 80 and LUNs 81 and 82 are
presented to the SR2122-2 then they may appear on the SR2122-2 as LUN 81 and 82 for the
controller.
A reboot of the SR2122-2 will set them correctly to LUN 1 and LUN 2.
Ports FC1 and FC2 are set to Loop Preferred by default
During the initial setup of the SR2122-2, the user is asked to specify whether the Fibre
Channel ports are connected to an Fibre Channel hub or Fibre Channel switch. Although
switch is the only supported option, the Fibre Channel ports are set to Loop Preferred.
To reset the Fibre Channel ports to the correct setting, Point-to-Point, the user may use the
Configuration Tab in the SR2122-2 GUI or the SR2122-2 CLI command:
SR2122> Interface FC1 Topology ptp
iSCSI CRC support
The iSCSI CRC feature is not supported with Windows 2000, Windows 2003, and Red Hat
Linux.
The iSCSI CRC feature is supported for HP-UX.