Harbor Freight Tools CENTRAL PNEUMATIC 68128 - Manual (Page 9)

SKU 68128 For technical questions, please call 1-800-444-3353. Page 9
For Reverse, turn the Direction Knob 5.
to the desired Reverse speed.
NOTE: There are three torque settings
for the Reverse direction. To loosen,
set the Regulator Knob to one of the
Reverse settings.
Hold the Side Handle firmly and place
6.
other hand around Handle (28). Gen-
tly squeeze the Trigger (49).
Place socket (not included) over
7.
desired nut, hold handle firmly and
gently squeeze the Trigger.
If tool requires more force to
8.
accomplish task in Forward or
Reverse setting, verify that the tool
receives sufficient, unobstructed
airflow (CFM) and increase the
pressure (PSI) output of regulator up
to maximum air pressure rating of the
tool.
CAuTION! TO PREVENT TOOL
ANd ACCESSORY FAILuRE,
RESuLTINg IN INjuRY:
do not exceed tool’s maximum air
pressure rating (90 PSI).
If tool still does not have sufficient
force at maximum pressure and
sufficient airflow, then a larger tool
may be required.
When the nut is tightened or loos-
9.
ened, release the Trigger. Use a
torque wrench to check the torque of
the tightened nut.
To prevent accidents, turn off tool,
10.
detach air supply, safely discharge
any residual air pressure in tool, and
release Trigger after use. Clean ex-
ternal surfaces of tool with clean, dry
cloth, and apply a thin coat of tool oil
to the anvil end. Store indoors out of
children’s reach.