Harbor Freight Tools CENTRAL PNEUMATIC 68128 - Manual (Page 8)

SKU 68128 For technical questions, please call 1-800-444-3353. Page 8
trapped line pressure, and detach air
supply hose from the air supply.
Note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion
after disconnecting to ensure that the
tool is disconnected and unpowered.
OPERATINg INSTRuCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Inspect tool before use, looking
for damaged, loose, and
missing parts. If any problems
are found, do not use tool until
repaired.
Tool Set up
TO PREVENT
SERIOuS INjuRY:
do not adjust or tamper with
any control or component in a
way not specifically explained
within manual. Improper
adjustment can result in tool
failure or other serious
hazards.
For added stability, attach Side Han- 1.
dle (5) to side of Hammer Case (4)
using Bolts (6) and Washers (7). .
Work Piece and Work Area Set up
Designate a work area that is clean 1.
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
Route air hose along a safe route
2.
to reach work area without creat-
ing a tripping hazard or exposing air
hose to possible damage. Also avoid
sharp bends and do not place items
on hose during use.
The air hose must be long enough
3.
to reach the work area with enough
extra length to allow free movement
while working.
There must not be hazardous objects
4.
(such as utility lines) nearby that will
present a hazard while working.
general Operating Instructions
WARNINg! 1. Use only 1” Drive Impact
type sockets (not supplied).
If an automatic oiler is not used,
2. add
a few drops of Pneumatic Tool Oil
to the airline connection before use.
Add a few drops more after each
hour of continual use.
Push and snap socket (not included)
3.
onto Anvil (13).
This Impact Wrench can be used in
4.
either Forward or Reverse direction.
To operate in Forward, turn the Direc-
tion Knob (33) under the housing to
the desired Forward speed.
NOTE: There are three torque settings
for the Forward direction. To tighten,
place the socket over the hex nut you
wish to tighten.