Harbor Freight Tools CENTRAL PNEUMATIC 68128 - Manual (Page 4)

SKU 68128 For technical questions, please call 1-800-444-3353. Page 4
Store the tool when it is idle out of e.
reach of children and other un-
trained persons. A tool is dangerous
in the hands of untrained users.
Maintain the tool with care.
f. A
properly maintained tool is easier to
control.
Check for misalignment or bind-
g.
ing of moving parts, breakage of
parts, and any other condition that
affects the tool’s operation. If dam-
aged, have the tool serviced before
using. Many accidents are caused
by poorly maintained tools. There is a
risk of bursting if the tool is damaged.
use only accessories that are
h.
identified by the manufacturer for
the specific tool model. Use of an
accessory not intended for use with
the specific tool model, increases the
risk of injury to persons.
Service
Tool service must be performed a.
only by qualified repair personnel.
When servicing a tool, use only
b.
identical replacement parts. use
only authorized parts.
use only the lubricants supplied
c.
with the tool or specified by the
manufacturer.
Air source
a. Never connect to an air
source that is capable of
exceeding 200 PSI. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry,
regulated compressed air at the rated
pressure or within the rated pressure
range as marked on the tool. Always
verify prior to using the tool that the
air source has been adjusted to the
rated air pressure or within the rated
air-pressure range.
Never use oxygen, carbon dioxide,
b.
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
SAVE THESE
INSTRuCTIONS.
SYMBOLS ANd
SPECIFIC SAFETY
INSTRuCTIONS
Symbol Definitions
Symbol Property or statement
n
o
No-load speed
.../min
Revolutions or reciprocation per
minute
PSI
Pounds per square inch of pressure
ft-lb
Foot-pounds of torque
BPM
Blows per minute
CFM
Cubic Feet per Minute flow
SCFM
Cubic Feet per Minute flow at
standard conditions
NPT
National pipe thread, tapered
NPS
National pipe thread, straight
Chart continued in next column.