Using the channel menu – HP MR4000N User Manual
Page 20
12
Using the HP HDTV Tuner
Using the Channel Menu
To display the Channel menu, press the Menu button on your remote control, select (highlight) the
Channel option, and press the Select button.
Using auto memorizing to set up your channels
Auto memorizing scans for a signal for all of the VHF and UHF channels in your area. If a signal is
found, it adds the channel to your channel list. Follow these steps to set auto memorizing for your
channels:
1 Press the Menu button on your remote control.
2 Highlight Channel, and press the Select button.
3 Highlight Auto Memorizing, and press the Select button.
4 Highlight AIR, STD, HRC, or IRC (whichever is in your broadcast area), and press the Select
button.
5 Highlight Confirm, and press the Select button to begin the auto memorizing process.
6 A list of channels that were detected is displayed when the auto memorizing is complete. Press the
Exit button to leave the OSM, or use the Up and Down arrow buttons to scroll through your
channels.
Programming favorite channels
You can assign the channels you watch most often as your favorite channels. Then you can use the
Fav-CH button on your remote control to access them easily. Follow these steps to assign your favorite
channels:
1 Press the Menu button on your remote control.
2 Highlight Channel, and press the Select button.
3 Highlight Favorite Channel, and press the Select button.
4 Use the Up and Down arrow buttons on your remote control to highlight each channel.
5 Press the Select button on your remote control to assign a channel as a favorite channel. A yellow
dot appears next to the channel number.
6 Press the Exit button on your remote to leave the OSM.
7 Press the Fav-CH button on your remote control to access your favorite channels.
Adding and deleting channels
You can customize your channel list by adding channels that were not initially detected and by
deleting channels you do not ever watch. Follow these steps to add and delete channels:
1 Press the Menu button on your remote control.
2 Highlight Channel, and press the Select button.
3 Highlight Channel Add/Delete, and press the Select button.