Harman-Kardon AVR 5550 - Manual (Page 47)

PROGRAMMING THE REMOTE 47
Programming the Remote
Resetting the Remote Memory
As you add components to your home-theater
system, occasionally you may wish to totally repro-
gram the remote control without the confusion of
any commands, macros or ”Punch-Through“
programming that you may have done. To do this,
it is possible to reset the remote to the original
factory defaults and command codes by following
these steps. Note, however, that once the remote
is reset, all commands or codes that you have
entered will be erased and will need to be re-
entered:
1. Press any of the Input Selector buttons 4
and the ”O“ button H at the same time until
the Program/SPL Indicator 2 begins to flash
amber.
2. Press the ”3“ button H three times.
3. The red LED under the Input Selector 4 will
go out and the Program/SPL Indicator 2 will
stop flashing and turn green.
4. The Program/SPL Indicator 2 will remain
green until the remote is reset. Note that this may
take a while, depending on how many commands
are in the memory and need to be erased.
5. When the Program/SPL Indicator 2 goes
out, the remote has been reset to the factory
settings.