Husqvarna 18 ProFlex - Manual (Page 40)

38
– English
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 kp/cm 2 )
all round.
To improve driving the pressure on the rear tyres
can be reduced to 40 kPa (0.4 kp/cm
2 ).
The maximum tyre pressure is 100 kPa (1.0 kp/cm 2 ).
IMPORTANT INFORMATION
Different tyre pressures on the front tyres
will result in the blades cutting the grass
at different heights.
MAINTENANCE
Cleaning the pulse air filter
1. Loosen the two rubber straps and lift off the
engine hood.
2. Loosen the four quick-action clips and lift off the
cover and remove the filter.
3. Blow out the filter using compressed air.
4. Replace the filter in the cover and secure the
cover using the quick-action clips. Replace the
engine hood.
Replacement of the fuel filter
Replace the fuel filter every 100 running hours
(once per season) or more frequently if it is
clogged.
Replace the filter as follows:
1. Dismantle the engine hood as described on
page 18.
2. Move the hose clips away from the filter. Use a
pair of flat pliers.
3. Pull off the filter from the hose ends.
4. Press in the new filter on the hose ends. If
necessary soap solution can be applied on the
filter ends to simplify fitting.
5. Push the hose clips back on the filter and
tighten.