Husqvarna 18 ProFlex - Manual (Page 27)

English –
25
5. Fit the height setting arm’s rear bracket when
fitting the attachment. Off-load the arm by
pulling the front of the frame upwards.
6. Remove the belt adjuster’s spring and fit the belt
on the front belt pulley.
7. Hook on the belt adjuster’s spring again.
MAINTENANCE
4. Slide in the unit so that the inner pins (B) bottom
in the attachment frame’s groove.
Note!
Check that the belt is fitted around the
tension roller.
Belt diagram
1. Drive belt
2. Drive pulley
3. Tension roller
4. Spring
B
2
3
4
1