HP Vectra XW User Manual

Page 11

Complete the Questionnaire to Check Your Understanding

Draw a circle around each letter that corresponds with a correct answer.
(There may be more than one correct answer to each question).

1 The following single-processor computer, supplied with a 2 GB hard disk,

has had components added by the user, and now no longer works. Which
of the following could be the source of its failure to operate properly?

a It has been fitted with a second Pentium Pro processor that was not

ordered from HP.

b There is a pair of 16 MB non-ECC memory modules in B1 and B2.

c There is a 32 MB ECC memory module in memory socket D1, but

socket D2 is empty.

d Memory sockets C1 and C2 are empty.

e There is a pair of non-HP memory modules in bank A.

An 850 MB IDE hard disk drive has been fitted in the lowest front-ac-
cess shelf, and has been connected to the spare grey IDE socket.

g A coax-socket network-board has been installed as a PCI accessory.

2 What does the user need to do before running an OpenGL graphics

application?

a Nothing, the appropriate drivers are integrated in the Windows NT WS

operating system.

b The specific drivers must be installed, manually, from the HP Drivers

CD-ROM.

c Either (a) or (b), depending on which operating system is being run.

3 How do you extend the memory capacity to 512 MB of a model that is

supplied with 64 MB of main memory?

a It cannot be extended to 512 MB. Only to 256 MB (=4 banks ✕ 64 MB).

b It cannot be extended to 512 MB. Only to 448 MB (=3 banks ✕ 128 MB

plus the original bank of 64 MB).

c The original bank of 64 MB can be removed, leaving room for 512 MB

(= 4 banks ✕ 128 MB).

1book.bk : 1ch01.fb4 Page 9 Friday, May 2, 1997 4:50 PM