Harbor Freight Tools 90692 - Manual (Page 6)

SKU 90692 PAGE 6
3. Install one Lower Vertical Support Bar (46) onto the Tool Rest Base of the lathe ,
and secure it by tightening the Support Bar Handle of the lathe. (See Figure A.)
4. Loosen the Tailstock Handle of the lathe , and remove the Tailstock from the Bed
of the lathe . (See Figure B.)
TAILSTOCK
HANDLE
TAILSTOCK
5. Loosen the Hex Nut (17) from the bottom of the Tool Rest Base (44) and Support
Bar Insert (53), and slide the Tool Rest Base assembly onto the Bed of the
lathe . Then, re-tighten the Hex Nut. (See Figure B.)
6. Replace the Tailstock of the lathe onto the Bed of the lathe, and secure it by
tightening the Tailstock Handle of the lathe . (See Figure B.)
To Install The U-Bracket Assembly:
1. Screw one Pattern Bolt (42) into the side of one Pattern Support Bar (41) and
secure the Pattern Bolt with a Hex Nut (39). Then, slide the Pattern Support Bar
into one U-Bracket (38). (See Figure C, next page.)
2. Screw one Handle (3) into the U-Bracket (38). (See Figure C.)
3. Insert the U-Bracket (38) onto the Lower Vertical Support Bar (46), and secure
the U-Bracket by tightening the Handle (3). (See Figure C.)
4. Repeat Steps #1, #2, #3 for the remaining U-Bracket Assembly.
(See Figure C.)
FIGURE B
HEX NUT (17)
TOOL REST BASE
(44)
SUPPORT BAR INSERT (53)
LOWER VERTICAL
SUPPORT BAR
(46)
SUPPORT BAR
HANDLE
(45)
TOOL REST HANDLE
(55)
BED OF LATHE