Harbor Freight Tools 90692 - Manual (Page 5)

SKU 90692 PAGE 5
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagram on page 14.
To Attach The Tool Rest Base:
1. Loosen the Tool Rest Handle of the lathe , and slide the Tool Rest Base of the
lathe to as near the Headstock of the lathe as possible. (See Figure A.)
2. Loosen the Support Bar Handle of the Model 90265 lathe , and remove the Tool
Rest Base of the lathe . (See Figure A.)
11. Keep the Lathe Duplicator Attachment dry and its moving parts properly
oiled for better and safer performance.
12. WARNING! Some dust created by power sanding, sawing, grinding, drilling,
lathe operations, and other construction activities, contain chemicals known (to
the State of California) to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are: lead from lead-based paints, crystalline
silica from bricks and cement or other masonry products, arsenic and chromium
from chemically treated lumber. Your risk from these exposures varies, depend-
ing on how often you do this type of work. To reduce your exposure to these
chemicals: work in a well ventilated area, and work with approved safety equip-
ment, such as those dust masks that are specially designed to filter out micro-
scopic particles.
(California Health & Safety Code 25249.5, et seq.)
FIGURE A
HEADSTOCK
LOWER VERTICAL
SUPPORT BAR
(46)
SUPPORT BAR HANDLE
TOOL REST BASE
TOOL REST
HANDLE
MODEL 90265 LATHE
NOT INCLUDED.