HONDA Outboard Motor BF135A - Manual (Page 97)

95
SUBMERGED MOTOR WATER SEPARATOR
BUZZER SOUNDS WATER SEPARATOR
INDICATOR
Digital Speedometer
TAKING CARE OF UNEXPECTED PROBLEMS
WATER SEPARATOR
A submerged outboard motor must
be serviced immediately after it is
recovered from the water in order to
minimize corrosion.
Remove the engine cover, and
rinse the outboard motor with
fresh water to remove salt water,
sand, mud, etc.
Drain the vapor separator as
described on p.
.
If there is a Honda marine dealer
nearby, take the motor to the dealer
immediately. If you are far from a
dealer, proceed as follows:
When the water separator buzzer
sounds (a rapid, repeating signal):
Check the water separator for water
contamination. If water is
accumulated, stop the engine, and
clean the water separator following
the instructions on page
, or
consult with an authorized Honda
marine dealer.
When the water separator indicator
blinks.
Check the water separator for water
contamination. If water is accumlated,
stop the engine, and clean the water
separator following the instructions
on page
, or consult with an
authorized Honda marine dealer.
1.
2.
74 74
80
Normal
Abnormal
04/01/21 11:24:40 31ZY6600_096