HONDA Outboard Motor BF135A - Manual (Page 75)

2.5 lbf·ft (3.4 N·m , 0.35 kgf·m)
73
SERVICING YOUR OUTBOARD MOTOR
FUEL FILTER STRAINER
BRACKET
ALIGNMENT
POSITION
STRAINER
CUP
SUSPENSION
STRAP
Align the center of suspension
strap with the screw position and
install the fuel filter assembly.
Reinstall the strainer in the original
position.
Remove the three screws and
separate the fuel strainer cup from
the strainer body.
Thoroughly clean the strainer cup,
and replace with a new fuel filter.
Reassemble the strainer body and
the cup.
STRAINER TIGHTENING
TORQUE:
Reinstall the strainer in the original
position.
8.
7.
9. Prime the engine using the priming
bulb (refer to page ). Check for
fuel leaks. Repair any fuel leaks if
necessary.
If loss of power or hard starting are
found to be caused by excessive
water or sediment accumulation in
the fuel filter, inspect the fuel tank.
Clean the fuel tank and tank filter if
necessary. It may be necessary to
drain the fuel tank completely and
refill with fresh gasoline.
7.
4.
5.
6.
36
04/01/21 11:20:16 31ZY6600_074