HP LTN1565 - Manual (Page 15)

2.5
I N S TA L L AT I O N
3
Connect a coaxial cable
between the ANTENNA
OUT terminal on the
VCR and the antenna
terminal on the TV.
4
Connect a set of audio
cables between the
AUDIO OUT jacks on
the VCR and the AUDIO
jacks on the TV.
5
Connect a video cable
between the VIDEO
OUT jack on the VCR
and the VIDEO jack on
the TV.
Follow the instructions in “Viewing a VCR or Camcorder Tape” to view your VCR tape.
A coaxial cable is usually included with a VCR.
(If not, check your local electronics store).
If you have a “mono” (non-stereo) VCR, use the Y-connector (not supplied) to
hook up to the left and right audio input jacks of the TV.
If your VCR is stereo, you must connect two cables.
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or
a cable TV system (according to the instructions on pages 2.1-2.3).
Skip step 1 if you have not yet connected to an antenna or a cable system.
1
Unplug the cable or
antenna from the back
of the TV.
2
Connect the cable or
antenna to the
ANTENNA IN terminal
on the back of the VCR.
VCR Rear Panel
VCR Rear Panel
VCR Rear Panel TV Rear Panel
TV Rear Panel
TV Rear Panel
Coaxial Cable
Audio Cable
Video Cable
Pr Audio(L) Audio(R)
06-CHAPTER 2_en 2/25/03 9:22 AM Page 5