Henny Penny MP-944 - Manual (Page 17)

Model MP-941/942/943/944
probe clip a metal holder that attaches to the outside of the control panel to hold the
food probe when not in use; the clip is an optional accessory
product load capacity
the highest recommended number of pounds/kilograms of food product that
can be safely held in the cabinet
proof function
a program used for allowing bread to rise
relative humidity
the humidity level outside the cabinet
setpoint
a preset temperature or humidity; the setpoint is a programmable feature
system initialization
a programming process that resets factory settings
temperature setting
a preset temperature up to which the cabinet will heat; this setting is
programmed at the factory but can be changed in the field
vent activation switch
an automatic control that opens and closes the vent on the rear of the
cabinet to maintain the preset humidity level
vented panels
openings on the cabinet that allow air access on the sides and rear of the
module
water fill line
the line marked on the inside of the water pan that shows the maximum
water level to prevent overflow onto the floor
water heater sensor
a part in the water heater that sends a message to the controls when the
water pan is limed up or empty
water jet
a device that shoots a stream of water under pressure; this type of device
should NOT be used to clean a holding cabinet
water pan
the area in the cabinet that holds water for creating humidity inside the
cabinet
G-2 103