Hobart Welding Products CHAMPION 4500 - Manual (Page 20)

OM-4418 Page 16
SECTION 5 − INSTALLATION
5-1. Installing Welding Generator
Ref install1 8/06 − Ref. 151 556 / 158 936-A / 803 467-C / S-0854
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm) 18 in
(460 mm)
18 in
(460 mm)
Movement Airflow Clearance
Location
! Always securely fasten welding
generator onto transport vehicle
or trailer and comply with all
DOT and other applicable codes.
! Do not install unit where air
flow is restricted or engine
may overheat.
3 Rating Label − Typical
Locate rating label on unit. Label pro-
vides information such as weld output
ratings, generator ratings, and engine
information.
.
Evidence of label tampering voids
warranty.
Ref: rot_label 2008-01 − 803 467
1
5-2. Rating Label Location