HP MSL6000 Series - Manual (Page 168)

Optional Fibre Channel Card 168
Connectors and Indicators
Figure 82 shows the connectors and indicators for the optional Fibre Channel board.
Figure 82 Connectors and indicators
NOTE: The Fibre Channel board serial cable is not the same as the library controller board serial
cable. The serial pinouts are different for each board, requiring different cables.
IMPORTANT: The Fibre Channel card can be reset by using a paper clip or other sturdy tool to
push the reset switch shown above the Power LED in Figure 82 .
Power Indicator
The Fibre Channel card has one power LED X. LED definitions:
• Green - power has been applied
• Yellow - POST is in process or processor problems present
Serial Port
The Fibre Channel card has one serial port Y. The serial port can be used to access the
Serial/Telnet user interface, which is used to locally manage and configure the Fibre Channel card.
1 Power LED
2 Serial RJ-11 connector
3 Ethernet RJ-45 connector
4 Fibre Channel activity LED
5 Fibre Channel link LED
6 FC-LC connector
7 SCSI VHDCI connector (2)
Fibre Channel
LVD/SE SCSl
0 1
Ether
net
Ser
ial
Pwr
.
Link/ Act
1
2
3
4
5
6
7
!