HONDA FL5540K1 - Manual (Page 37)

STORAGE
STORAGE
END OF SEASON
1. If loader is to be dismounted from the
tractor during storage, make sure parking
area is on hard, level ground.
2. Store in a dry, sheltered area, if possible.
Note: All hydraulic cylinders should be in the
retracted position.
3. Thoroughly clean the loader of all
accumulated dirt and grease.
4. Completely lubricate the loader as
specified in lubrication section of manual.
5. Using an oil soaked cloth, lubricate all
hydraulic cylinder rods to protect them
from rust and corrosion.
6. Repaint any areas where paint is worn or
damaged.
7. Wear areas on buckets or other
attachments should be coated with grease
to prevent rust or corrosion.
8. Replace any safety or warning labels that
are not readable due to wear or damage.
-Do not allow children to play
on or around the tractor or loader.
PROCEDURES
BEGINNING OF SEASON
1.
2.
3.
4.
5.
6.
7.
a.
9.
Review safety precautions and operation
sections of manual.
Thoroughly clean loader of all
accumulated dirt and grease.
If removed from tractor for storage,
remount loader per “Loader Installation’’
section of this manual.
Completely lubricate the loader per the
lubrication section of this manual. Make
sure all fittings are taking grease properly.
Clean with solvent any exposed surfaces
which had been coated with grease. Wipe
dry with a clean cloth, then lubricate with
an oil soaked cloth.
Tighten any bolts that may have been
loosened and make sure all pins are in
place.
Start tractor and operate loader to make
sure it is operating properly and all hoses
are properly connected.
Check hydraulic fluid level in loader mast
and
fill if required. Use oil recommended
in this manual.
Make sure hydraulic hoses, lines and
fittings are in good shape and are not
leaking. Repair or replace as needed.
Ensure rear weight box is in place and
is properly weighted.
35