beautypg.com

Warning – Hearth and Home Technologies GO24-IPI-LP User Manual

Page 7

background image

Hearth & Home Technologies • Grand Oak Gas Log Sets • 4004-299 Rev H • 05/08

7

I. For Natural Gas Installation (for all units)

• Pour sand into the burner pans to the point where the

burner pipe is covered. See Figure 5. Level the sand

from right to left to ensure an even flame pattern. At this

point the pan should be half full. Be sure not to cover pilot

assembly.

• Pour vermiculite over the sand in the pans until they are

full. See Figure 6.

Note: For best results, do not pack down the rock wool.

The placement of rock wool can have an effect on flame

pattern and may need to be adjusted to achieve a desired

appearance.

Fire Risk

Explosion Risk

Personal Injury Risk
Failure to position the parts in accordance

with the diagrams provided with the log

packages or failure to use only parts

approved with this appliance may result in

property damage or personal injury.

WARNING

Figure 6

Placing Vermiculite

Figure 5

Sand

Figure 7

Placing Rock Wool

• Lightly place dime-size pieces of rock wool evenly on top

of the sand and vermiculite to achieve a glowing ember

effect. See Figure 7.

Inspect the pilot burner to ensure it is clear of any

rock wool.

• Remove the Platinum Bright Embers™ from the package.

For optimum performance peel each piece apart in layers

and lightly place on top of the vermiculite and rock wool

where the flame is blue. This will achieve the desired

realism.

• The gas burns at the point of the least resistance. In

case of an uneven flame pattern it may be necessary to

adjust the materials in the pans (using an object such as

a screwdriver) to achieve the desired effect.

• Place desired amount of lava granules on the floor of the

fireplace. DO NOT ALLOW THE GRANULES TO COME

IN CONTACT WITH THE FLAMES. (Lava granules may

contain moisture which, when heating, may cause it to pop

out during installation and set-up.) Ensure the controls

and switches are unobstructed after the granules are

installed.

• Place logs. See Sections S thru Y.

• Place accent logs around burner on floor of fireplace.