Harbor Freight Tools CENTRAL MACHINERY 95668 - Manual (Page 19)

SKU 95668 For technical questions, please call 1-800-444-3353 PAGE 19
B. Between two cutters: This set-up has the advantage of making two profile
cuts in a single pass. Although there is a Rub Collar (98, 99, 100) beneath a
Cutter, this set-up is safer than the previous set-up. Any lifting of the
workpiece will still cause the Cutter to make an uneven cut. A second pass
will correct the profile on the bottom edge, but the top profile will still have the
gouge from lifting the workpiece into the Cutter. (See Figure BB.)
BETWEEN
RUB cOLLAR
(98, 99, 100)
cUTTER
cUTTER
FIgURE BB
c. Below the cutter: This set-up allows the cut to be viewed by the operator.
However, it is also the most dangerous. Any slight lifting of the workpiece will
cause the Cutter to make too deep of a cut. There is also increased risk of
kickback. It is NOT recommended to shape with a Rub collar below the
cutter. (See Figure cc.)
NOT REcOMMENDED
BELOW
RUB cOLLAR
(98, 99, 100)
cUTTER
FIgURE cc
OPERATINg INSTRUcTIONS
1. Use safety equipment. Always wear ANSI-approved safety impact
eye goggles. Dust mask or respirator, and hearing protection must be
used for appropriate conditions.