Harbor Freight Tools CENTRAL MACHINERY 95668 User Manual

Page 18

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 18

the left to lower the Spindle (105).

(See Figure Z.)

Retighten the Spindle Hand Knob (92) on the side of the Wood Shaper. DO NOT

overtighten the Knob. Only a small amount of tension is needed to keep the

Spindle (105) from moving during operation.

(See Figure Y.)

FIgURE Y

FIgURE Z

SPINDLE

HAND KNOB

(92)

SPINDLE

HEIgHT KNOB

(120)

Rub Collars:

When shaping workpieces that have irregular shapes, Rub Collars (98, 99, 100)

are a necessity. Some examples of when you would use a Rub Collar are raising

arched or tombstone door panels, round table tops, or any other cut that needs

to have its depth of cut limited.

There are three set-up positions for Rub Collars (98, 99, 100):

A. Above the cutter: This set-up is the safest and produces a most consistent

result. The only drawback is that the cut is on the underside of the

workpiece, out of view of the operator. However, if the workpiece lifts off the

Work Table (52) you simply run it through a second time to finish the cut.

(See Figure AA.)

ABOVE

RUB cOLLAR

(98, 99, 100)

cUTTER

FIgURE AA