Harbor Freight Tools CENTRAL MACHINERY 95668 User Manual

Page 15

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 15

Table Inserts:

Table Inserts (53, 53A) are used to reduce wood chips falling into the machine

which could cause flying debris. Using the smallest Table Insert also covers any

unused portion of the bit below the surface of the Work Table (52).

(See Figure R.)

Position, and snap in the Table Insert (53, 53A) you wish to use.

(See Figure R.)

Make sure the Table Insert (53, 53A) is seated and flush with the Work Table (52)

surface.

(See Figure R.)

TABLE INSERT

(53, 53A)

WORK TABLE

(52)

FIgURE R

Belt Adjustment:

The Wood Shaper uses a Belt (123) on two Pulleys (113, 127) to compensate

for different Belt positions as the Spindle (105) height is adjusted. To adjust the

V-Belt:

Loosen the two Hex Head Screws (134). Slide the Motor (129) position to

increase or decrease V-Belt (123) tension, so that the Belt is snug with about 1/4”

deflection when pressed lightly with your finger. Then, retighten the Hex Head

Screws.

(See Figure S.)

V-BELT (123)

HEX HEAD ScREW

(134)

MOTOR (129)

FIgURE S