Harbor Freight Tools CENTRAL MACHINERY 95668 User Manual

Page 10

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 10

Place the Wood Shaper’s Work Table (52) upside down on two sturdy blocks

that are at least 3-1/2” off the floor. Make sure the Spindle (105) DOES NOT

touch the floor or the weight of the Wood Shaper may damage the Spindle.

(See Figure g.)

Place the Stand assembly on the Wood Shaper and attach it with the Carriage

Bolts (9), 3/8” Flat Washers (10), and Hex Nuts (11). Then have an assistant

help you turn the Wood Shaper unit upright.

(See Figure g.)

Level the Wood Shaper with a carpenter’s level. If necessary, move the Stand

slightly until it is level. Then, tighten all Bolts and Nuts on the Stand.

FIgURE g

STAND ASSEMBLY

WORK TABLE

(52)

Optional Table Spacer Installation:

Your shaper comes with a Table Spacer Installation Kit that will enable you

to make shallow cuts and utilize the upper blade area of most router bits with

shanderd-length shanks. This is an optional feature that is not required for most

applications.
Unplug the shaper power cord. Remove the four table corner Hex Bolts (66),

then remove the three Spindle Housing Hex Bolts (95). Lift the Table (52) off of

the stand assembly.

(See Figure g above and the assembly diagram on page

29.)

Locate the package, (included with your shaper), that contains all the hardware

for installing the spacers. There should be five M12 Long Bolts (151), two M12

Short Bolts (152) and seven 1/2” Spacers (150). Position one spacer over each

of the four corner bolt holes and one over each of the three spindle housing bolt

holes.

(66)

(28)

REV 07j