Harbor Freight Tools 95801 - Manual (Page 5)

Page 5 SKU 95801 For technical questions, please call 1-800-444-3353.
5. Never lay the tool down until it has come to a complete stop. Moving parts
can grab the surface and pull the tool out of your control.
6. Never leave this Air Hammer unattended when it is plugged into an air supply.
Turn off the tool, and unplug it from an air supply before leaving.
7. WARNING: Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities, contains chemicals known [to the State of
California] to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
Lead from lead-based paints
Crystalline silica from bricks and cement or other masonry products
Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area,
and work with approved safety equipment, such as those dust masks that are spe-
cially designed to filter out microscopic particles. (California Health & Safety Code
§ 25249.5, et seq.)
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
NOTE: READ ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
SETUP
Figure 1
NOTE: For best service, you should incorporate an oiler, regulator, and in-line filter
as shown in Figure 1 above. Hoses, couplers, oilers, regulators and filters are all
available at Harbor Freight Tools.
If you are not using an automatic oiler system, before operation add a few drops of
Pneumatic Tool Oil (not included) to the airline connection. Add a few drops after
each hour of continual use.