Hitachi VT-FX601A - Manual (Page 49)

TROUBLESHOOTING GUIDE - 49 -
Cable Converters Press CATV and This Number
Jerrold 1
1
Jerrold 2 2
Jerrold 3 3
Hamlin 4
Zenith
5
Scientific Atlanta 6
Pioneer 7
Philips
8
TO OPERATE THE CABLE BOX ONCE THE REMOTE IS
PROGRAMMED FOR IT.
1 Press CATV and then the button of the function you want.
2 Press VCR button to operate your VCR with the remote again.
TROUBLESHOOTING GUIDE
If you have followed the instructions contained in this manual and have difficulty in
operating your VCR, locate the SYMPTOM in the left column below. Check the
corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to remedy the
problem.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
No power. • Power cord is not connected. • Connect power cord to AC outlet.
• The VCR power is turned off. • Press POWER button to turn on the
VCR.
Timer recording is • The timer recording is set incorrectly. • Set the timer recording
correctly.
not possible. • The VCR power is turned on. • Press POWER button to turn off
the VCR.
• VCR clock is not set correctly. • Set VCR clock correctly.
Recording mode • The erase prevention tab on • Place a plastic tape over the hole.
cannot be engaged. cassette is missing.
No picture or poor • The TV and/or VCR is in the TV • Set your TV to the the VCR mode
picture on playback. mode.
and/or press VCR/TV button so that the
VCR/TV indicator on the VCR comes
on.
• The TV fine tuning is not set • Fine tune your TV.
correctly.
Noise in picture on • Video heads are dirty.
• Head cleaning is necessary, consult
playback. the nearest Funai Authorized Service
Center.
Playback picture is • The tracking control is not set • Adjust tracking control for a better
partially
noisy. correctly. picture using CHANNEL or
button. See page 16.
On-the-air TV • Connections are not correctly made. • Re-check the ANT.IN and
programs cannot be ANT.OUT connections. .
seen. • The TV and/or VCR is in VCR Set your TV to the TV mode and/or
mode. press VCR/TV button so that the