Hatco IMPERIAL "S" - Manual (Page 19)

Form No. EBOOSTERM-0406 17
INSTALLATION
ALL MODELS
Booster Heaters are shipped with most components
pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to unit
and components enclosed. Components are
shipped with the heater unit. (See Figure 7.)
1. Remove unit from box.
2. Remove information packet. To prevent delay
in obtaining warranty coverage, fill out and
mail in the warranty card to Hatco.
3. Remove tape and protective packaging from all
surfaces of unit.
4. If your unit is equipped with legs, carefully lay
unit on its side and install the four legs as shown
in Figure 4.
CAUTION
Do not lay unit on the side with the control panel
or damage to unit could occur.
NOTE: If unit is not level, use an adjustable open-
end wrench to adjust the foot of each leg until unit is
level. Each leg is adjustable from 6" (152 mm) to 7"
(178 mm).
5. On Compact Series, when installing unit with
mounting brackets, space slide rails as shown in
Figure 5 and weld rails to bottom of dishtable.
WARNING
To avoid personal injury or damage to the
equipment make sure the dishtable is strong
enough to support the weight of the booster
heater and water when installing with slide
mounting brackets.
WARNING
To avoid personal injury or damage to the
equipment, follow standard welding procedures
when attaching sliderails to bottom of dishtable.
6. Using Hatco slide brackets as a template, drill
1/8" (3 mm) holes into the sides of the heater
jacket.
7. Attach slide brackets to sides of heater with
3/4 x 8 sheet metal screws supplied. (See
Figure 5.)
8. Slide heater onto slide rails under dishtable.
(See Figure 6.)
Figure 4. Installing Legs
Figure 5. Hanging Support
Weld slide rail
to bottom of
dish table
Fasten slide
brackets to
booster heater
sides
Figure 6. Compact Series Heater Mounted to Dishtable