Husqvarna Rider 11 - Manual (Page 23)

English –
21
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cable is removed from the plug.
• The parking brake is applied.
• The cutting unit is disengaged.
Maintenance
50 25 100
MAINTENANCE
Page
Maintenance interval
in hours
Daily
mainte-
nance
before start
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.
● = Described in these instructions.
❍ = Not described in these instructions.
1) First change after 5 hours. 2) During dusty conditions cleaning and replacement should be more frequent. 3) For daily use of the
machine lubrication should be conducted twice a week. 4) Conducted by authorised service workshop.
Check the engine’s oil level 37 ●
Check the engine’s cooling air inlet 30 ●
Check the fuel pump’s air filter 28 ●
Check the steering wires 24 ●
Check the brakes 25 ●
Check the battery 28 ●
Check the safety system 29 ●
Check screws and nuts – ❍
Check for fuel and oil leakage – ❍
Change the engine oil 1) 37 ●
Clean the air filter’s pre-filter (foam plastic) 2) 27 ●
Check the cutting unit 31 ●
Check the tyre pressures (60 kPa) 30 ●
Lubricating the belt adjuster 3) 38 ●
Lubricate joints and shafts 3) 39 ●
Adjust the brakes – Rider 11 and Rider 11 Bio 25 ●
Check the V-belts – ❍
Check the transmission’s cooling flanges – – ❍
Rider 13 and Rider 13 Bio
Check the transmission’s oil level – Rider 13 and 39 ●
Rider 13 Bio
Adjust the brakes – Rider 13 and Rider 13 Bio
25 ●
Check and adjust the throttle wire 26 ●
Clean the cooling flanges on the engine and – ❍
transmission 2,4)
Replace the air filter’s pre-filter and paper filter 2) 27 ●
Replace the fuel filter 26 ●
Replace the plug 28 ●