Heath Zenith LED Lighted Push Button with Keyfinder Light 598-1281-02 - Manual (Page 2)

598-181-0
1. Using a small screwdriver, push in tab
on bottom of push button to remove
back (see Figure 1).
2. Insert wires through hole in center of
push button back. Attach back to wall
with screws provided (see Figure 2).
Installation
IMPORTANT: DO NOT install addi-
tional diode(s) to push button. Additional
diode(s) will cause chime to malfunction.
Figure 2 - Attach Back to Wall
Figure 1 - Remove Push Button Back