Hoover Z 400 - Manual (Page 17)

3. To remove the agitator, use a
screwdriver placed as shown.
5. If the end plates have loos-
ened, tighten them by turning in
opposite directions.
4. Use one hand to remove the
agitator as you use leverage to lift
the agitator with the end of the
screwdriver. Remove old belt.
6. Place one end of the new belt over the metal motor pulley. Lettering
on belt should be visible and not against pulleys. Slip the other end
around the plastic pulley end of the agitator. (See illustration)
1 6