Husqvarna 260 ACX - Manual (Page 22)

22 - English
3. INSTALLATION
Best position for the boundary wire
The boundary wire should be laid so it:
• Forms a loop around the working area for
Automower
® . Only an original boundary wire must
be used. This is tinned and has a high quality
insulation to withstand the dampness in the
ground.
• Maintains a maximum distance of 100 ft
(35 metres) from Automower
® in the entire working
area.
• Ideally not longer than 1600 ft (500 metres). For
installations where a longer boundary wire of up to
800 metres is required, we recommend a Signal
amplifier (522 42 58-01) which is available as an
accessory.
• The boundary wire is laid at different distances
from obstacles depending on what the working
area borders. The picture below shows how the
boundary wire should be routed around the
working area and around obstacles.
0”
4”
14” 16”