Hitachi CP-D10 - Manual (Page 43)

43
OPTION menu
Item Description
AUTO
POWER OFF
Using the ▲/▼ cursor buttons adjusts the time to count down to
automatically turn the projector off.
Long (max. 99 minutes) Short (min. 0 minute = DISABLE)
When the time is set to 0, the projector is not turned off automatically.
When the time is set to 1 to 99, and when the passed time with no-
signal or an unsuitable signal reaches at the set time, the projector
lamp will be turned off.
If one of the projector's buttons or the remote control buttons
is pressed or one of the commands (except get commands) is
transmitted to the CONTROL port during the corresponding time,
projector will not be turned off.
Please refer to the section the “Turning off the power”
(
14).
LAMP TIME
The lamp time is the usage time of the lamp, counted after the last
resetting. It is shown in the OPTION menu.
Pressing the ► cursor (or the ENTER / the RESET) button displays
a dialog.
To reset the lamp time, select the OK using the ► cursor button.
CANCEL OK
• Please reset the lamp time only when you have replaced the lamp,
for a suitable indication about the lamp.
• For the lamp replacement, see the section the “Replacing the
lamp” (
53, 54).
FILTER TIME
The filter time is the usage time of the air filter, counted after the last
resetting. It is shown in the OPTION menu.
Pressing the ► cursor (or the ENTER / the RESET) button displays
a dialog.
To reset the filter time, select the OK using the ► cursor button.
CANCEL OK
• Please reset the filter time only when you have cleaned or replaced
the air filter, for a suitable indication about the air filter.
• For the air filter cleaning, see the section the “Cleaning and
replacing the air filter” (
55).
(continued on next page)