beautypg.com

Warning, Stop, Halt – Huffy M731324 User Manual

Page 4: Alto! alto, Alto, Gehen sie nicht zum laden zurück

background image

4

ID# M731324

11/05

BEFORE YOU START!

AVANT DE COMMENCER!

VORBEREITENDE MASSNAHMEN

¡ANTES DE COMENZAR!

Questions or Missing Parts

Call TOLL-FREE Customer Service

Number listed on the front page!

Des questions ou des
pièces manquantes ?

Appelez le numéro du service clientèle

(NUMÉRO GRATUIT) qui figure en première page!

STOP!

STOP!

Des questions ou des
pièces manquantes ?

Appelez le numéro du service clientèle

(NUMÉRO GRATUIT) qui figure en première page!

STOP!

NE RETOURNEZ PAS au magasin !

NE RETOURNEZ PAS au magasin !

Fragen oder fehlende Teile?

Rufen Sie die GEBÜHRENFREIE Telefonnummer
(in den USA und Kanada) auf der Vorderseite an!

HALT!

HALT!

Fragen oder fehlende Teile?

Rufen Sie die GEBÜHRENFREIE Telefonnummer
(in den USA und Kanada) auf der Vorderseite an!

Gehen Sie NICHT zum Laden zurück!

Gehen Sie NICHT zum Laden zurück!

HALT!

¿Tiene preguntas o le faltan piezas?

¡Llame al número telefónico GRATUITO de Servicio

al Cliente que se indica en la primera página!

¡¡ALTO!

ALTO!

¿Tiene preguntas o le faltan piezas?

¡Llame al número telefónico GRATUITO de Servicio

al Cliente que se indica en la primera página!

¡NO regrese a la tienda!

¡NO regrese a la tienda!

¡ALTO!

To ensure optimal playability of backboard system, a close tolerance fit

between the elevator components and hardware is required. Test-fit large bolts

into large holes of elevator tubes, backboard brackets, and triangle plates.
Carefully rock them in a circular motion to ream out any excess paint from

holes if necessary.

Not all items pictured are included with every model.

Pour garantir l'utilisation optimale du panneau, les composants du système

élévateur et la visserie doivent être bien ajustés (serrés). À titre d'essai, insérez

les gros boulons dans les gros trous des tubes du système élévateur, des

supports du panneau et des plaques triangulaires. Basculez-les avec

précaution en imprimant un mouvement circulaire pour éliminer l'excédent de

peinture des trous, si nécessaire.

Les composants illustrés ici ne sont pas tous fournis avec chaque modèle.

Um sicherzustellen, dass das Korbwandsystem optimal für den Spielbetrieb

geeignet ist, müssen die Komponenten der Verlängerungsvorrichtung und die

verschiedenen Befestigungsteile fest miteinander verschraubt werden. Große

Schrauben zur Probe in die großen Löcher der Verlängerungsrohre,

Korbwandklammern und Dreiecksplatte stecken und diese vorsichtig in einer

Kreisbewegung hin- und herbewegen, um eventuelle Farbrückstände aus den

Bohrungen zu entfernen.

Nicht jedem Modell sind alle abgebildeten Teile beigepackt.

Para asegurar el óptimo rendimiento del sistema del respaldo en el juego, se

requiere un ajuste de tolerancia estrecha entre los componentes del elevador y

el herraje. Pruebe el ajuste de los pernos grandes en los orificios grandes de

los tubos elevadores, soportes del respaldo y placas triangulares.

Cuidadosamente muévalos en círculos para eliminar cualquier exceso de

pintura de los orificios, si es necesario.

No todos los artículos ilustrados se incluyen con cada modelo.

10-3/4" High

4" Wide

PMS 021 for Warning

Owner must ensure that all players know and follow these rules

for safe operation of the system.

WARNING

DO NOT HANG on the rim or any part of the system including
backboard, support braces or net.

During play, especially when performing dunk type activities,
keep player's face away from the backboard, rim and net.
Serious injury could occur if teeth/face come in contact with
backboard, rim or net.

Do not slide, climb, shake or play on base and/or pole.

After assembly is complete, fill system completely with water
or sand and stake to the ground. Never leave system in an
upright position without filling base with weight, as system
may tip over causing injuries.

When adjusting height or moving system, keep hands and
fingers away from moving parts.

Do not allow children to move or adjust system.

During play, do not wear jewelry (rings, watches, necklaces,
etc.). Objects may entangle in net.

Surface beneath the base must be smooth and free of gravel or
other sharp objects. Punctures cause leakage and could cause
system to tip over.

Keep organic material away from pole base. Grass, litter, etc.
could cause corrosion and/or deterioration.

Check pole system for signs of corrosion (rust, pitting,
chipping) and repaint with exterior enamel paint. If rust has
penetrated through the steel anywhere, replace pole
immediately.

Check system before each use for proper ballast, loose
hardware, excessive wear and signs corrosion and repair
before use.

Check system before each use for instability.

Do not use system during windy and/or severe weather
conditions; system may tip over. Place system in the storage
position and/or in an area protected from the wind and free
from personal property and/or overhead wires.

Never play on damaged equipment.

See instruction manual for proper installation and
maintenance.

When moving system, use caution to keep mechanism from
shifting.

Keep pole top covered with cap at all times.

Do not allow water in tank to freeze. During sub-freezing
weather add 2 gallons of non-toxic antifreeze, sand or empty
tank completely and store. (Do not use salt.)

While moving system, do not allow anyone to stand or sit on
base or have added ballasting on base.

Do not leave system unsupervised or play on system when
wheels are engaged for moving.

Use Caution when moving system across uneven surfaces.
System may tip over.

Use extreme caution if placing system on sloped surface.
System may tip over more easily.

Read and understand warnings listed
below before using this product.

Failure to follow these warnings may
result in serious injury and/or property
damage.

ID#: 556790 01/05

MUNSELL NOTATION
Hue

Value Chroma

5.0 YR

6.0/15

Equiv. CIE Data
(Y%)

x

y

30.05

0.5510

0.4214

Approx. PMS Color
13 parts yellow
3 parts Warm Red
1/4 part Black

Warning Area = Orange

Size = 4" x 6.5"

Corner Radius = 3/8"

Die Cut Label

3.25 Mil Vinyl

All Temp. Permanent Adhesive

1 Mil. Polypropolyne Overlaminate

Illustrator 8.0 = EPS

Backing + 1/16 Circumference

Rolls of 500

In the U.S.: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx

In the U.S.: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx

In the U.S.: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx

In the U.S.: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx