Honeywell RCA902N User Manual

Page 10

Text mode
Original mode

Installation Instructions

69-2157EFS—05

NOTE: The detector can be configured to work with either a Chime or a Switching
Receiver in Day or Night mode. It cannot work with both.

• Mark the position of the fixing holes and drill two 6 mm holes, then insert the

wall plugs (supplied). If fixing to non-solid or wood surface the wall plugs will not
be needed and only a small pilot hole will be required.

• Clip a 9V PP3 (6LR61) Alkaline battery to the connector and fit the battery in its

holder.

NOTE: When the battery is connected the LED behind the detector lens will continu-
ously flash or stay ON while the detector goes through its
warm up cycle. The unit will not operate normally until the
LED stops flashing.

• Fix the unit in place on the wall and then close the

cover ensuring it clicks fully closed.

• Adjust the sensor head to point in approximately the

desired direction.

M27296

Fig. 4

69-2157EFS_C.indd 8

9/22/2008 11:54:00 AM